Show mac address table dynaic secure static

#Show mac address table dynaic secure static full#

A reload can be canceled with reload cancel.

It is possible to program the switch to reload a few minutes ahead in case you lose control: reload in where n is the number of minutes to wait before reloading. When modifying the configuration, it can be useful to reload the switch in certified mode if a configuration error occur. view running configuration: show configuration snapshot or write terminal.reboot in working mode without rollback: reload working no rollback-timeout.save running even in certified mode: configuration snapshot all Then move this file to working/boot.cfg.save working -> certified: copy working certified, flash-synchro will synchronize the conf accross all slots.Configuration files are stored in certifed/boot.cfg and working/boot.cfg (they can be directly edited with 'vi'). When booting, if working and certified configuration files are different, the switch will boot in certified mode. In working mode, the configuration can be modified, while it is no possible in certified mode (well, actually, it is). Managing the configuration filesДЄlcatel Omniswitchs can operate in two modes: working and certified (show running-directory to know in which mode the switch is).

#Show mac address table dynaic secure static full#

The full documentation can be found on Alcatel-Lucent website. This page is based on the notes I took when managing Alcatel Omniswitchs 6600, 6800 in 2007 and later 6850. Д«asic commands on Alcatel Omniswitch Introduction Latouche: Basic commands on Alcatel Omniswitch Website of latouche